Waveshare USB Blaster V2 Download-Kabel, kompatibel mit ALTERA USB Blaster FPGA/CPLD-Programmiergerät, High-Speed-Lösung mit FT245+CPLD

Beschreibung

Waveshare USB Blaster V2 Download-Kabel, kompatibel mit ALTERA USB Blaster FPGA/CPLD-Programmiergerät. Das USB Blaster Download-Kabel verbindet einen USB-Anschluss eines Host-Computers mit einem auf einer Leiterplatte montierten Altera FPGA. Das Kabel überträgt Konfigurationsdaten vom PC an einen Standard-10-Pin-Stecker, der mit dem FPGA verbunden ist. Sie können das USB Blaster-Kabel verwenden, um während des Prototypings Konfigurationsdaten iterativ an ein System herunterzuladen oder während der Produktion Daten in das System zu programmieren.

Es unterstützt die meisten ALTERA FPGA/CPLD-Geräte, Active Serial Configuration-Geräte und Enhanced Configuration-Geräte und unterstützt die drei Download-Modi AS, PS und JTAG.

Key Features

• • Hardware Solution
    • High speed FT245+CPLD+244 solution, similar download speed as the original ALTERA USB Blaster, with the same operation.
    • Download speed 1-3 times faster than other schemes, such as 68013 or C8051F.
  • Performance
    • Supports most of the ALTERA FPGA/CPLD devices, Active Serial Configuration devices, and Enhanced Configuration Devices.
    • Supports AS, PS, JTAG three download modes.
    • High-speed, stable, and internal FT245R+CPLD designed.
    • Supports 1.2-5V programming voltage.
    • Supports Nios II of embedded processor communication and debugging.
  • Supported Softwares
    • Quartus II integrated development environment.
    • NIOS II IDE integrated development environment.
    • NIOS II EDS integrated development environment.
  • Supported Devices Tested devices are listed below, including but not limited to:
    • CPLD: MAX3000, MAX7000A/B/S, MAX9000 and MAX II etc.
    • FPGA: Stratix, Stratix II, Cyclone, Cyclone II, CycloneIII, ACEX 1K, APEX 20K and FLEX 10K etc.
    • Active Serial Configuration Devices including: EPCS1, EPCS4, EPCS16 etc.
    • Enhanced Configuration Devices including: EPC1, EPC4 etc.
  • Connects to PC
    • Computer connection via USB 2.0 interface.
  • Connects to target board
    • Target board connection via JTAG, AS, PS interfaces. The figure 1, 2,and 3 below shows the header pinouts of different interfaces.
    Figure 1. JTAG header pinout

    Figure 2. AS header pinout

    Figure 3. PS header pinout

  ---

LED Status

• Red LED: Power indicator
• Green LED: Signal indicator, the LED is on while downloading/programming

Downloads

Development resources:user manual, software, etc. Wiki:www.waveshare.com/wiki/USB_Blaster_V2

Lieferumfang

1. USB Blaster V2 × 1
2. USB Cable × 1
3. 10-pin cable × 1